This is an old revision of the document!
The Traktor Kontrol Z1 is a small, portable 2-deck controller with an integrated soundcard.
A mapping for the Kontrol Z1 exists that maps all controls to Mixxx just as they are labelled. A few extra functions are available to make this controller usable by itself without other controllers:
You can use the Kontrol Z1 as a sound output. Channel 1-2 will go to the Main Out, two RCA jacks at the top of the controller, with volume being regulated by the “Main” knob. Channel 3-4 will go to the phones, a single 3.5mm stereo jack at the bottom of the controller, with volume being regulated by the “Cue Vol” knob.
Note: The “Main” and “Cue Vol” controls operate on the hardware level and thus do not send any signals
Report ID: 0x1
Each control spans 2 Bytes, but only sends up to 12 Bits. These are the controls in order in which they are sent.
Each of these knobs exists twice, first are all that are one the left and then all on the right.
Left Vertical Fader
Right Vertical Fader
The buttons all are at an offset of 29 and and are listed here with their bitmask:
Report ID: 0x80
All bytes represent Brightness and can be set granularly from 00 to 7F (Even though Traktor always sends either 0A or 7F).