User Tools

Site Tools


numark_mixtrack_platinum

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
numark_mixtrack_platinum [2018/11/25 10:22]
be.ing
numark_mixtrack_platinum [2018/11/30 01:18] (current)
iamcodemaker tweak vu meter documentation
Line 39: Line 39:
 **Shift+Cue Gain:** adjust the volume of the first 8 sampler banks **Shift+Cue Gain:** adjust the volume of the first 8 sampler banks
  
-5. **VU Meter:** Monitor the volume levels of the master output and each channel. When cue/pfl is active on any channel, the meter shows the levels ​for each channel. Otherwise the meter shows the levels of the master output.+5. **VU Meter:** Monitor the volume levels of the master output and each channel. When cue/pfl is active on ANY channel, the meter shows the mono levels each channel ​(left meter shows the deck on the left, right meter for the deck on the right). Otherwise the meter shows the stereo ​levels of the master output.
    
 6. **Load:** Press one of these buttons while a track is selected in the library window to assign it to Deck 1 and 2 (or 3 and 4), respectively,​ in the software.\\ 6. **Load:** Press one of these buttons while a track is selected in the library window to assign it to Deck 1 and 2 (or 3 and 4), respectively,​ in the software.\\
Line 160: Line 160:
  
 ===Sample Mode=== ===Sample Mode===
-Hold Pad Mode and press the pad marked Sampler to enter sampler mode (hold down shift as well to control slots 5-8 using the hotcue buttons). A press of any of the sample buttons will load a sample if non are loaded. Shift + sample pad will unload a sample if it is not playing. Pressing a pad when a sample is loaded will play the sample, pressing shift + sample pad while a sample is playing will stop it.+Hold Pad Mode and press the pad marked Sampler to enter sampler mode (hold down shift as well to control slots 5-8 using the hotcue buttons). A press of any of the sample buttons will load a sample if the sampler is not loaded. Shift + sample pad will unload a sample if it is not playing. Pressing a pad when a sample is loaded will play the sample, pressing shift + sample pad while a sample is playing will stop it.
  
 Use **shift+cue gain** to adjust the volume of the sampler. When switching to the pad mode to sampler, hold down shift to control slots 5-8 using the hotcue buttons. Use **shift+cue gain** to adjust the volume of the sampler. When switching to the pad mode to sampler, hold down shift to control slots 5-8 using the hotcue buttons.
  
-Note: the 8 sample slots on each deck all control the same 8 slots in Mixxx no matter which deck the sampler is active on.+Note: the 8 sample slots on each deck all control the same 8 slots in Mixxx no matter which deck the sampler is active on. This is because the controller sends the same MIDI codes for button presses on each side, so there is no way for Mixxx to tell whether a sampler button was pressed on the left or right side of the controller.
  
numark_mixtrack_platinum.1543159344.txt.gz ยท Last modified: 2018/11/25 10:22 by be.ing